Filter
Top Products
ADIC/GRAU DAS and STK ACS Libraries
The STK ACS Library Device
Chapter 14 685
ACSSA> query cap all
The format specification of an ACS CAP has to be the following:
ACS CAP: ID:#,#,#,# - (ACS num, LSM num, PANEL,
DRIVE).
✓ Make sure that the CAPs that will be used for Data Protector are
in the state online and in manual operating mode.
If a CAP is not in the state online, change the state using the
following command:
vary cap <cap_id> online
If a CAP is not in manual operating mode, change the mode using
the following command:
set cap manual <cap_id>
✓ A list of UNIX device files for the drives.
Run the ioscan -fn system command on your system to display
the required information.
For more information on UNIX device files, see HP OpenView
Storage Data Protector Installation and Licensing Guide
Remote
Installation
The installation procedure consists of the steps:
1. Distribute the ACS Agent component to clients using the Data
Protector graphical user interface and Installation Server for UNIX.
See the HP OpenView Storage Data Protector Installation and
Licensing Guide.
2. Physically connect the library drives and the systems where you have
installed ACS Agent.
See http://www.openview.hp.com/products/datapro/spec_0001.html
for
details about supported StorageTek devices.
See the HP OpenView Storage Data Protector Installation and
Licensing Guide for information about how to physically attach a
backup device to the system. Also see the documentation that comes
with the StorageTek library.
3. To start the ACS ssi daemon
• on UNIX ACS client, run the following command: