Filter
Top Products
ADIC/GRAU DAS and STK ACS Libraries
The STK ACS Library Device
Chapter 14684
You should see the library drives with corresponding device
files/SCSI addresses displayed in the list.
Installing the ACS Media Agent on a 32-bit HP-UX System
Prerequisites The following prerequisites for installation have to be met before
installing the ACS Agent on an HP-UX system:
• The StorageTek library has to be configured and running. See the
documentation that comes with the StorageTek library.
• Data Protector has to be installed and configured. See the HP
OpenView Storage Data Protector Installation and Licensing Guide.
• The following information has to be obtained before you start
installing the ACS Agent software:
✓ The <hostname> of the host where ACSLS is running.
✓ A list of ACS drive IDs that you want to use with Data Protector.
To display the list, login on the host where ACSLS is running and
execute the following command:
rlogin “ACSLS hostname” -l acssa
✓ You will have to enter the terminal type and wait for the command
prompt. At the ACSSA prompt, enter the following command:
ACSSA> query drive all
The format specification of an ACS drive has to be the following:
ACS DRIVE: ID:#,#,#,# - (ACS num, LSM num, PANEL,
DRIVE).
✓ Make sure that the drives that will be used for Data Protector are
in the state online. If a drive is not in the online state, change
the state with the following command on ACSLS host:
vary drive <drive_id> online
✓ A list of available ACS CAP IDs and ACS CAP format
specification. To display the list, login on the host where ACSLS is
running and execute the following command:
rlogin “ACSLS hostname” -l acssa
You will have to enter the terminal type and wait for the command
prompt. At the ACSSA prompt, enter the following command: