Filter
Top Products
ADIC/GRAU DAS and STK ACS Libraries
The STK ACS Library Device
Chapter 14 683
If a CAP is not in manual operating mode, change the mode using
the following command:
set cap manual <cap_id>
✓ A list of SCSI addresses for the drives, for example, scsi4:0:1:0.
For more information on SCSI addresses, see HP OpenView
Storage Data Protector Installation and Licensing Guide.
Remote
Installation
The installation procedure consists of the steps:
1. Distribute the ACS Agent component to clients using the Data
Protector graphical user interface and Installation Server for
Windows.
2. Physically connect the library drives and the systems where you have
installed ACS Agent.
See http://www.hp.com/go/dataprotector
/specification for details about
supported StorageTek devices.
3. To start the ACS ssi daemon
• On the Windows ACS client and the Cell Manager, install the
LibAttach service. Make sure that during configuration of
LibAttach service the appropriate ACSLS hostname is entered.
After the successful configuration the LibAttach services are
started automatically and will be started automatically after the
boot as well.
NOTE After you have attached the LibAttach service, check if the
libattach\bin directory has been added to the system path
automatically. If not, add it manually.
• For more information on the service see the documentation that
comes with the StorageTek library.
4. Run the following command to check whether or not the library
drives are properly connected to your system:
• On Windows ACS client,
<Data_Protector_home>\bin\devbra -dev