Filter
Top Products
ADIC/GRAU DAS and STK ACS Libraries
The STK ACS Library Device
Chapter 14682
• Data Protector has to be installed and configured. See HP OpenView
Storage Data Protector Installation and Licensing Guide.
• The following information has to be obtained before you start
installing the ACS Agent software:
✓ The <hostname> of the host where ACSLS is running.
✓ A list of ACS drive IDs that you want to use with Data Protector.
To display the list, login on the host where ACSLS is running and
execute the following command:
rlogin “ACSLS hostname” -l acssa
✓ You will have to enter the terminal type and wait for the command
prompt. At the ACSSA prompt, enter the following command:
ACSSA> query drive all
The format specification of an ACS drive has to be the following:
ACS DRIVE: ID:#,#,#,# - (ACS num, LSM num, PANEL,
DRIVE).
✓ Make sure that the drives that will be used for Data Protector are
in the state online. If a drive is not in the online state, change
the state with the following command on ACSLS host:
vary drive <drive_id> online
✓ A list of available ACS CAP IDs and ACS CAP format
specification. To display the list, login on the host where ACSLS is
running and execute the following command:
rlogin “ACSLS hostname” -l acssa
You will have to enter the terminal type and wait for the command
prompt. At the ACSSA prompt, enter the following command:
ACSSA> query cap all
The format specification of an ACS CAP has to be the following:
ACS CAP: ID:#,#,# (ACS num, LSM num, PANEL, DRIVE).
✓ Make sure that the CAPs that will be used for Data Protector are
in the state online and in manual operating mode.
If a CAP is not in the state online, change the state using the
following command:
vary cap <cap_id> online