Filter
Top Products
Intel
®
IXP42X product line and IXC1100 control plane processors—Universal Serial Bus (USB)
v1.1 Device Controller
Intel
®
IXP42X Product Line of Network Processors and IXC1100 Control Plane Processor
DM September 2006
504 Order Number: 252480-006US
This bit can be used to validate the other status/error bits in the Endpoint 10 Control/
Status Register. The UDCCS10[TPC] bit is cleared by writing a 1 to it. This clears the
interrupt source for the IR10 bit in the appropriate UDC status/interrupt register, but
the IR10 bit must also be cleared.
The UDC issues NAK handshakes to all IN tokens if this bit is set and the buffer is not
triggered by writing 8 bytes or setting UDCCS10[TSP].
18.5.12.3 Flush Tx FIFO (FTF)
The Flush Tx FIFO bit triggers a reset for the endpoint's transmit FIFO. The Flush Tx
FIFO bit is set when software writes a 1 to it or when the host performs a
SET_CONFIGURATION or SET_INTERFACE.
The bit’s read value is 0.
18.5.12.4 Transmit Underrun (TUR)
The transmit underrun bit is be set if the transmit FIFO experiences an underrun. When
the UDC experiences an underrun, NAK handshakes are sent to the host.
UDCCS10[TUR] does not generate an interrupt and is for status only. UDCCS10[TUR] is
cleared by writing a 1 to it.
18.5.12.5 Sent STALL (SST)
The sent stall bit is set by the UDC in response to FST successfully forcing a user-
induced STALL on the USB bus. This bit is not set if the UDC detects a protocol violation
from the host PC when a STALL handshake is returned automatically. In either event,
the Intel XScale
®
processor does not intervene and the UDC clears the STALL status
when the host sends a CLEAR_FEATURE command.
The endpoint operation continues normally and does not send another STALL condition,
even if the UDCCS10[SST] bit is set.
To allow the software to continue to send the STALL condition on the USB bus, the
UDCCS10[FST] bit must be set again. The Intel XScale
®
processor writes a 1 to the
sent stall bit to clear it.
18.5.12.6 Force STALL (FST)
The Intel XScale
®
processor can set the force stall bit to force the UDC to issue a STALL
handshake to all IN tokens. STALL handshakes continue to be sent until the Intel
XScale
®
processor clears this bit by sending a Clear Feature command.
The UDCCS10[SST] bit is set when the STALL state is actually entered, but this may be
delayed if the UDC is active when the UDCCS10[FST] bit is set. The UDCCS10[FST] bit
is automatically cleared when the UDCCS10[SST] bit is set.
To ensure that no data is transmitted after the Clear Feature command is sent and the
host resumes IN requests, software must clear the transmit FIFO by setting the
UDCCS10[FTF] bit.
18.5.12.7 Bit 6 Reserved
Bit 6 is reserved for future use.