Filter
Top Products
C122-E003-02EN 3-43
MMB
3.2 System Menu
Redundancy Redundancy statuses of DC-to-DC converters #0 and #1:
• Redundant: Redundancy is maintained.
• Non-redundant: Sufficient Resources: Redundancy is lost, but
there are enough converters to continue system operation.
• Non-redundant: Insufficient Resources: Redundancy is lost, and
there are not enough converters to continue system operation.
DDC#00 to #01 Statuses of DC-to-DC converters #0 and #1:
• OK: Operating normally
• Not-present: Not installed
• Configuration error: Configuration error
• Failed: Failure
Redundancy Redundancy statuses of DC-to-DC converters #02 to #04.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
DDC#02 to #04 Statuses of DC-to-DC converters #02 to #04.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
Redundancy Redundancy statuses of DC-to-DC converters #05 to #06.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
DDC#05 to #06 Statuses of DC-to-DC converters #05 to #06.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
Redundancy Redundancy statuses of DC-to-DC converters #07 to #13.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
DDC#07 to #13 Statuses of DC-to-DC converters #07 to #13.
These statuses are displayed in the same way as the redundancy
statuses of DC-to-DC converters #00 and #01.
SSM Slow-start circuit status:
• OK: Operating normally
• Failed: Failed
Voltage
Sensor Voltage sensor type
Voltage Current voltage reading
Threshold Warning
(Low/High)
Lower and upper limits of the warning-level voltage. If no limit is
set, a hyphen (-) is displayed.
Critical
(Low/High)
Lower and upper limit of the critical-level voltage. If no limit is
set, a hyphen (-) is displayed.
Item Description