Fujitsu 440 Laptop User Manual


 
3-66 C122-E003-02EN
MMB
CHAPTER 3 Web-UI Operations
Table 3.43 Displayed and setting items in the [MMB#x] window
Item Description
Status MMB status:
OK: Operating normally
Not present: Not installed
Degraded: Component failure (The faulty component can be
isolated to continue operation.)
Failed: Failure
Role MMB operation status:
Active: Operating
Standby: Standby mode
Disabled: Set to the non-operational status
Part Number MMB part number
Serial Number MMB serial number
MAC address MAC address of the MMB management port.
Firmware Version MMB firmware version
Location LED Location LED status
The three light statuses are as follows:
On: Currently lit
Off: Currently not lit
Blink: Currently blinking
The LED can be turned on, turned off, or set to blink by clicking a
radio button.
Reset MMB Check this check box to reset the MMB.
If this check box is checked, the [Switch Over to MMB] check box
described below cannot be checked.
Switch Over to MMB Check this check box to toggle between the active and standby
modes of the MMB.
If this check box is checked, the [Reset MMB] check box
described above cannot be checked.
Note: This field is displayed only if two MMBs are installed.
Enable/Disable MMB This field can be used to enable and disable the MMB.
Enable: Places the added MMB in standby state.
Disable: Disables the MMB.
When an MMB is added to the PRIMEQUEST-series machine, its
initial status is disabled. The MMB already operating in the
machine has the active status. To place the added MMB in the
standby status, enable it by using this field.
Vo l t a g e
Sensor Voltage sensor type