Filter
Top Products
C122-E003-02EN 8-29
GSWB
8.2 Configuration Definition Commands
• Input parameter error.
Cause: An invalid parameter was entered.
Action: Enter the correct parameter.
• Command is already running.
Cause: One of the following commands is running.
restore config / save / save config / clear config
Action: Reexecute after exiting the command.
8.2.1.4 save config
This command copies the configuration definition file to the work area. If the work
area contains a file with the same name (config0, config1), the existing file is
overwritten.
Note: This command cannot be executed during execution of the clear config, clear
ramdisk, restore config, save, save config, or tftp command.
(1) Synopsis
• Copies the configuration definition file to the work area
(2) Options
z {config0 | config1} (optional)
- config0: Specifies config0.
- config1: Specifies config1.
By default, the configuration definition file of the booting memory bank is copied to
the work area.
(3) Command mode
enabled exec
(4) See also
clear config
clear ramdisk
restore config
save config [{config0 | config1}]