Filter
Top Products
8-226 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
(6) Error Messages
• % Not implement daughter card.
Cause: An unimplemented interface or an unimplemented chip was specified.
Action: Check the unit mounting status.
• Command is already running.
Cause: One of the following commands is running.
show bridge/clear bridge
Action: Reenter the command after the current command exits.
• % Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• System error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
8.3.6.2 show bridge summary
This command displays the number of entries registered in the learning table.
The displayed number of entries includes the MAC addresses used by the system.
Any change in the learning contents by hardware is reflected in the learning table
contents after about 5 to 10 seconds.
(1) Synopsis
show bridge summary [chip <chip no>]