Filter
Top Products
C122-E003-02EN 8-215
GSWB
8.3 Operation Commands
(6) Error Messages
• % Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• System error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
8.3.4.9 traceroute
This command examines the routes used to transfer packets to their destination.
Transmission to broadcast addresses is not supported.
(1) Synopsis
(2) Options
z <ip-address>
Specifies the destination address.
Specify the IP address basically in the form of xxx.xxx.xxx.xxx (xxx is a decimal
number ranging from 0 to 255).
z length <length> (optional)
Specifies the length of each packet to be transmitted (Unit: bytes).
You can specify a length between 40 and 1500 bytes. The packet length includes the
IP header.
The default packet length is 40 bytes.
traceroute <ip-address> [length <length>]