Filter
Top Products
8-76 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
• Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
• vlan id doesn’t exist.
Cause: The specified VLAN does not exist.
Action: Reenter the command after creating a VLAN.
• Input parameter error.
Cause: The VLAN specification is invalid.
Action: Review the VLAN specification.
• Invalid switchport mode.
Cause: The VLAN membership mode is not access.
Action: Reenter the command after changing the mode to access.
• It is necessary to review specified VLAN and port.
Cause: The VLAN and port definition do not match.
Action: Review the VLAN and port definitions.
8.2.9.5 switchport native vlan
This command specifies a VLAN to be allocated to traffic without tags:
z The VLANs that can be used in Trunk mode are determined by this command and
the switchport allowed vlan command.
z Trunk mode must be set before this command is executed. If the command is
executed in Access mode, no error message is displayed and no setting is made.
z The default setting is "switchport native vlan 1".
z Tagged frames of the VLAN specified by this command are also received.
However, VLAN frames specified by the command are sent without tags.
When making this setting for a port-channel port, no setting is required for a physical
link that is a part of the target port-channel. The contents of settings made for such
links are not reflected. The setting for a physical link in the port-channel is reflected
in the physical link at the time the link is removed from the port-channel.