Filter
Top Products
8-6 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
Parameters for which the input format is displayed in help information are not
completed.
Only the current parameter is completed. The next parameter (or command name) is
not completed.
8.1.5.4 Command editing function
This section describes how to specify and cancel commands.
z Specifying a command
To specify a command, switch to a command mode in which the command can be
specified, enter it in the CLI, and press the [Enter] key.
z Canceling a command (no)
To cancel a command, enter "no" in front of the command in the CLI, and execute it.
Subcommands can be canceled in submode.
Any subcommand that is specified under a command is also canceled when the
command is canceled.
8.1.5.5 Command selection display function
When the show command is executed, the command selection display function
displays the commands that can be specified in the current mode.
If the command is executed with part of a command name or command parameter
entered after "show", only the commands that match the specified parameter are
displayed.
Any subcommand that is specified under a command is also displayed when the
command is displayed.
8.1.5.6 Error messages
The appropriate action to be taken for a configuration definition command error
depends on the detected location and contents of the error message. The following
table lists the error messages that are common to all of the configuration definition
commands. For other error messages, see the command descriptions.