Filter
Top Products
8-94 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
(5) Examples
• Sets GigabitEthernet 0/1 statically for a multicast group (01:00:5e:02:02:03) of
VLAN 20
(6) Error Messages
• % Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
• Input parameter duplicate error.
Cause: Duplicated registration was attempted.
Action: Check the entries already registered.
• % Not implement daughter card.
Cause: TenGigabitEthernet was specified for the unit where TenGigabitEthernet was
not implemented.
Action: Check the device configuration.
• igmp static mac address max regist.
Cause: Specification exceeding the multicast table limit was attempted.
Action: Check the number of registered entries.
Switch(config)# vlan 20
Switch(config-vlan)# ip igmp snooping vlan static 01:00:5e:02:02:03 interface
GigabitEthernet 0/1
Switch(config-vlan)#