Filter
Top Products
8-52 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
Action: Check the entries already registered.
• % Not implement daughter card.
Cause: 10GigabitEthernet was specified for the port while no TenGigaEthernet
daughter card was implemented.
Action: Check the device configuration.
• It is necessary to review specified VLAN and port.
Cause: The VLAN and port definitions do not match.
Action: Review the VLAN and port definitions.
• Entry isn't existed.
Cause: The specified entry is not registered.
Action: Check the entered MAC address entry.
• mac address table is full.
Cause: The MAC address table is full.
Action: Wait until the MAC address table has a free space and then enter the
command again.
• Input parameter error.
Cause: An invalid parameter was specified.
Action: Specify the correct parameter.
8.2.8 Spanning tree protocol (STP) functions
8.2.8.1 spanning-tree
This command enables or disables STP for the whole device.
If BPDU frame transfer is enabled by the spanning-tree bpdufilter command, this
command cannot enable STP. To enable STP, disable BPDU frame transfer.
(1) Synopsis
• Enables STP for the whole device (default)
• Disables STP for the whole device
spanning-tree