Filter
Top Products
6-20 C122-E003-02EN
PSA
CHAPTER 6 CLI Operations
6.8 SNMP Security Setting Command (setsnmpsec)
The setsnmpsec command sets SNMP service security (sets the host that accepts
SNMP packets). If the SNMP service security setting is "Accept SNMP packets from
any host." you do not need to execute this command.
If the MMB IP address is changed after PSA installation in an environment where the
SNMP service security setting is "Accept SNMP packets from any host," execute this
command when the SNMP service security setting is changed from "Accept SNMP
packets from any host" to "Accept SNMP packets from these hosts."
(1) Synopsis
(2) Options
None
(3) Example
(4) Output messages
• Normal termination
FJSVpsa : I 04200 Security setting for SNMP Service was completed.
• Abnormal termination
FJSVpsa : E 04201 Anerror occurred at the time of security setting for SNMP
Service.
(5) Notes
After you execute this command, you need to restart the SNMP Service.
setsnmpsec
> setsnmpsec