Filter
Top Products
8-106 C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
(6) Error Messages
• % Incomplete command.
Cause: Incomplete command input
Action: Enter the command string correctly.
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• Internal communication error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
8.2.15 Access restriction functions
8.2.15.1 remote-access
This command specifies the host or network that can have remote connections:
z telnet and ssh are the protocols available to this command for access control.
z Even after connection permission is deleted (by executing the no remote-access
command), the telnet/ssh connection established to this device is maintained.
z The maximum number of conditions that can be set is 100.
z No connection is permitted at the time of shipment from the factory. To enable the
telnet server function/ssh server function, execute this command to make settings
to allow such connections.
z Use [remote-access <ip-address>] to permit access from a specific host.
z Use [remote-access <ip-address> <subnet-mask>] to permit access from a specific
network. If no network address is specified in <ip-address>, a connection from the
host of a specific network cannot be established.