Filter
Top Products
5-56 C122-E003-02EN
PSA
CHAPTER 5 Web-UI Operations
Table 5.35 Buttons in the [Watchdog] window
(1) Menu operation
[Partition] → [Partition #x] → [PSA] → [Setup] → [Watchdog]
(2) GUI operation
• Setting up Watchdog monitoring (when correct values are entered)
1 Select and enter values for the Watchdog monitoring settings, and click the
[Apply] button.
If the entered values are correct, the [Confirm Settings] dialog box opens.
Boot Watchdog
Watchdog The user can enable or disable Boot Watchdog monitoring:
• Disable: Disable monitoring
• Enable: Enable monitoring
The default setting is [Disable].
TimeOut The user can specify a timeout value in seconds, which is used
while Boot Watchdog monitoring is enabled:
Range: 60 to 6000 seconds
Specify a value calculated based on the period of time from the
time the partition is switched on to the time the console/Syslog
receives a startup completion message (the console displays
Starting PSA services: [OK] or Starting PSA services: [OK] or
Syslog includes "FJSVpsa: I00069 PM startup succeeded").
Fujitsu recommends setting a value that is at least twice this
elapsed time in order to prevent mistaken detection. Also,
consider the time taken to save a dump in the event of an OS panic.
You can only specify this item if you select [Enable]. The default
value is 0 seconds. Note that you always need to change the
default value.
Button Description
Apply Click the [Apply] button to set the values entered for Watchdog
monitoring. Clicking this button validates the settings for both
Software Watchdog and Boot Watchdog.
Cancel Click the [Cancel] button to clear the entered values and revert to
the original settings.
Item Description