Filter
Top Products
2-14 C122-E003-02EN
Basics
CHAPTER 2 Basic Operations
The navigation bar and menus are used for switching.
The current software used for operations can be determined from the submenu
hierarchy display bar, which shows the menu path to the displayed window.
to PSA
1 Click [Partition] on the navigation bar.
2 Select [Partition#n] → [PSA] from the Partition menu.
→ The PSA menu of the selected Partition#n is displayed.
to GSWB
1 Click [Switch] on the navigation bar.
→ The GSWB menu is displayed.
to MMB
1 Click [System] on the navigation bar.
→ The MMB menu is displayed.
Switching with CLI operations
An outline of switching with CLI operations is provided below.
The Telnet or SHH command from a PC connected to the management LAN is used
in CLI operations to switch to the target software for particular operations. The basic
operating procedure is to log in to the OS or firmware of the target of this operation by
executing the Telnet or SHH command with the corresponding IP address specified.
If the operation target is PSA, the MMB IP address and the port number of the login
partition are required. Information required for remote login, such as an IP address,
the port number of a partition, an account ID and a password, must be specified in
advance.
MMB
Specify the MMB IP address, and log in with a remote connection. (*1)
GSWB
Specify the GSWB0 (or GSWB1) IP address, and log in with a remote connection.
(*2)
GSWB through the MMB CLI
Specify 0 or 1, and execute the connect GSWB command to log in to the GSWB CLI.
connect GSWB {0|1}