Filter
Top Products
Developer’s Manual March, 2003 C-9
Intel
®
80200 Processor based on Intel
®
XScale
™
Microarchitecture
Test Features
C.2.5.5. Shift-DR State
In this controller state, the test data register, which is connected between TDI and TDO as a result
of the current instruction, shifts data one bit position nearer to its serial output on each rising edge
of TCK. Test data registers that the current instruction selects but does not place in the serial path,
retain their previous value during this state.
The instruction does not change while the TAP controller is in this state.
If TMS is high on the rising edge of TCK, the controller enters the Exit1-DR state. If TMS is low
on the rising edge of TCK, the controller remains in the Shift-DR state.
C.2.5.6. Exit1-DR State
This is a temporary controller state. When the TAP controller is in the Exit1-DR state and TMS is
held high on the rising edge of TCK, the controller enters the Update-DR state, which terminates
the scanning process. If TMS is held low on the rising edge of TCK, the controller enters the
Pause-DR state.
The instruction does not change while the TAP controller is in this state. All test data registers
selected by the current instruction retain their previous value during this state.
C.2.5.7. Pause-DR State
The Pause-DR state allows the test controller to temporarily halt the shifting of data through the
test data register in the serial path between TDI and TDO. The test data register selected by the
current instruction retains its previous value during this state. The instruction does not change in
this state.
The controller remains in this state as long as TMS is low. When TMS goes high on the rising edge
of TCK, the controller moves to the Exit2-DR state.
C.2.5.8. Exit2-DR State
This is a temporary state. If TMS is held high on the rising edge of TCK, the controller enters the
Update-DR state, which terminates the scanning process. If TMS is held low on the rising edge of
TCK, the controller enters the Shift-DR state.
The instruction does not change while the TAP controller is in this state. All test data registers
selected by the current instruction retain their previous value during this state.