Filter
Top Products
5-15
Cisco ASDM User Guide
OL-16647-01
Chapter 5 Using the Startup Wizard
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
• A DNS server on a higher level security interface cannot use PAT.
Fields
• Use Network Address Translation (NAT)—Choose to enable NAT and a range of IP addresses to be
used for translation.
• Starting Global IP Address—Specifies the first IP address in a range of IP addresses to be used for
translation.
• Ending Global IP Address—Specifies the last IP address in a range of IP addresses to be used for
translation.
• Subnet Mask (optional)—Specify the subnet mask for the range of IP addresses to be used for
translation.
• Use Port Address Translation (PAT)—Choose to enable PAT. Choose one of the following if you
select this option:
Note IPSec with PAT may not work correctly, because the outside tunnel endpoint device cannot
handle multiple tunnels from one IP address.
–
Use the IP address on the outside interface—Choose to use the IP address of the outside
interface for PAT.
–
Specify an IP address—Enter an IP address to be used for PAT.
IP Address—Specifies an IP address for the outside interface for PAT.
Subnet Mask (optional)—Choose a subnet mask from the drop-down list.
• Enable traffic through the firewall without translation—Choose to allow traffic through the firewall
without translation.
For More Information
See the Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide and the Cisco ASA
5505 Getting Started Guide.
Modes
The following table shows the modes in which this feature is available:
Step 15 - Administrative Access
This screen lets you configure management access on the security appliance.
Fields
• Type—Specifies whether the host or network is accessing the security appliance through HTTP over
SSL in ASDM, SSH, or Telnet.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • •—