Filter
Top Products
5-22
Cisco ASDM User Guide
OL-16647-01
Chapter 5 Using the Startup Wizard
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
–
Specify an IP address—Click to specify an IP address for an interface:
IP Address—Lets you enter an IP address for an interface.
Subnet Mask—Lets you enter or choose a subnet mask for an interface from the drop-down list.
–
Obtain default route using PPPoE—Click to obtain the default route between the PPPoE server
and the PPPoE client.
For More Information
See the Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide.
Modes
The following table shows the modes in which this feature is available:
Outside Interface Configuration
This screen lets you configure your outside interface by specifying an IP address, or obtaining one from
a PPPoE or a DHCP server. To access this feature from the main ASDM application window, choose
Configuration > Interfaces.
Note For all ASA 5500 series models except ASA 5505, with a full license, the adaptive security appliance
supports up to five interfaces, with a maximum of three outside interfaces. In restricted mode, the
adaptive security appliance supports up to three interfaces, and in transparent mode, the adaptive security
appliance supports up to two interfaces. After you have created the maximum number of interfaces, or
the maximum number of interfaces has already been named, you may not be able to create a new VLAN,
and must select an existing one.
Fields
• Interface—Choose an interface from the drop-down list.
• Interface Name—Adds a name to a new interface, or displays the name associated with an existing
interface.
• Enable interface—Check this check box to activate the interface in privileged mode.
• Security Level—Displays the security level range for the interface from 0 to 100, with 100 assigned
to the inside interface and 0 assigned to the outside interface. Perimeter interfaces can use any
number between 1 and 99. Security levels between 0 and 100 for perimeter interfaces are not set by
default.
• Use PPPoE—Click to obtain an IP address from a PPPoE server.
• Use DHCP—Click to obtain an IP address from a DHCP server.
• Obtain default route using DHCP—Check this check box to obtain an IP address for the default
gateway using DHCP.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • •—