Filter
Top Products
11-35
Cisco ASDM User Guide
OL-16647-01
Chapter 11 Configuring Dynamic And Static Routing
Dynamic Routing
Modes
The following table shows the modes in which this feature is available:
For More Information
• Configuring EIGRP, page 11-29
Interface
The Interface pane displays the EIGRP interface configurations. The Interface Parameters table displays
all of the interfaces on the security appliance and lets you modify the following settings on a
per-interface basis:
• Authentication key and mode.
• The EIGRP hello interval and hold time.
• The interface delay metric used in EIGRP metric calculations.
• The use of split-horizon on the interface.
To configure the EIGRP parameters for an interface, double-click an interface entry or select the entry
and click Edit. The Edit EIGRP Interface Entry dialog box appears.
Fields
The Edit EIGRP Interface Entry dialog box fields:
• Interface—Display only. Displays the interface being modified.
• AS—The EIGRP autonomous system number.
• Hello Interval—Enter the interval between EIGRP hello packets sent on an interface. Valid values
are from 1 to 65535 seconds. The default value is 5 seconds.
• Hold Time—Specifies the hold time, in seconds. Valid values are from 1 to 65535 seconds. The
default value is 15 seconds.
• Split Horizon—Check this check box to enable split horizon on the interface. Uncheck the check
box to disable split horizon. Split horizon is enabled by default.
• Delay—Enter the delay value in this field. The delay time is in tens of microseconds. Valid values
are from 1 to 16777215.
• Enable MD5 Authentication—Check this check box to enable MD5 authentication of EIGRP
process messages.
–
Key—Key to authenticate EIGRP updates. The key can contain up to 16 characters.
–
Key ID—Key identification value; valid values range from 1 to 255.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——