24-111
Cisco ASDM User Guide
OL-16647-01
Chapter 24 Configuring Application Layer Protocol Inspection
Inspect Map Field Descriptions
Add/Edit MGCP Group
The Add/Edit MGCP Group dialog box lets you define the configuration of an MGCP group that will be
used when MGCP application inspection is enabled.
Fields
• Group ID—Specifies the ID of the call agent group. A call agent group associates one or more call
agents with one or more MGCP media gateways. The valid range is from 0 to 2147483647.
• Gateways area
–
Gateway to Be Added—Specifies the IP address of the media gateway that is controlled by the
associated call agent. A media gateway is typically a network element that provides conversion
between the audio signals carried on telephone circuits and data packets carried over the
Internet or over other packet networks. Normally, a gateway sends commands to the default
MGCP port for call agents, 2727.
–
Add—Adds the specified IP address to the IP address table.
–
Delete—Deletes the selected IP address from the IP address table.
–
IP Address—Lists the IP addresses of the gateways in the call agent group.
• Call Agents
–
Call Agent to Be Added—Specifies the IP address of a call agent that controls the MGCP media
gateways in the call agent group. Normally, a call agent sends commands to the default MGCP
port for gateways, 2427.
–
Add—Adds the specified IP address to the IP address table.
–
Delete—Deletes the selected IP address from the IP address table.
–
IP Address—Lists the IP addresses of the call agents in the call agent group.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—