Filter
Top Products
12-19
Cisco ASDM User Guide
OL-16647-01
Chapter 12 Configuring Multicast Routing
PIM
–
Destination—Displays the multicast destination address.
• Insert Before—Opens the Request Filter Entry dialog box. Use this button to add a new multicast
group entry before the selected entry in the table.
• Insert After—Opens the Request Filter Entry dialog box. Use this button to add a new multicast
group entry after the selected entry in the table.
• Add—Opens the Request Filter Entry dialog box. Use this button to add a new multicast group entry
at the bottom of the table.
• Edit—Opens the Request Filter Entry dialog box. Use this button to change the information for the
selected multicast group entry.
• Delete—Removes the selected multicast group entry from the table.
Modes
The following table shows the modes in which this feature is available:
Request Filter Entry
The Request Filter Entry dialog box lets you define the multicast sources that are allowed to register with
the security appliance when the security appliance acts as an RP. You create the filter rules based on the
source IP address and the destination multicast address.
Fields
• Action—Choose “Permit” to create a rule that allows the specified source of the specified multicast
traffic to register with the security appliance; choose “Deny” to create a rule that prevents the
specified source of the specified multicast traffic from registering with the security appliance.
• Source IP Address—Enter the IP address for the source of the register message.
• Source Netmask—Enter or choose the network mask for the source of the register message.
• Destination IP Address—Enter the multicast destination address.
• Destination Netmask—Enter or choose the network mask for the multicast destination address.
Modes
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——