Filter
Top Products
CHAPTER
16-1
Cisco ASDM User Guide
OL-16647-01
16
Configuring Management Access
This chapter contains the following topics:
• Configuring Device Access for ASDM, Telnet, or SSH, page 16-1
• Configuring CLI Parameters, page 16-2
• Configuring File Access, page 16-4
• Configuring Configuring ICMP Access, page 16-7
• Configuring a Management Interface, page 16-9
• Configuring SNMP, page 16-9
• Configuring Management Access Rules, page 16-19
• Configuring AAA for System Administrators, page 16-20
Configuring Device Access for ASDM, Telnet, or SSH
This section describes how to allow clients to access the device using ASDM, Telnet, or SSH. To
configure access to the security appliance, perform the following steps:
Step 1 From the Configuration > Device Management > Management Access > ASDM/HTTPS/Telnet/SSH
pane, click Add.
The Add Device Access Configuration dialog box appears in the right-hand pane.
Step 2 Choose the type of session from the three options listed: ASDM/HTTPS, Telnet, or SSH.
Step 3 From the Interface Name drop-down list, choose the interface to use for administrative access.
Step 4 In the IP Address field, add the IP address of the network or host that is allowed access.
Step 5 From the Mask drop-down list, choose the mask associated with the network or host that is allowed
access.
Step 6 For ASDM/HTTPS sessions, verify that the Enable HTTP Server check box is checked (this is the
default setting).
Step 7 Make sure that port number 443 is specified (this is the default setting).
Step 8 For Telnet sessions, the default timeout value is 5 minutes. To change this value, type a new one in the
Telnet Timeout field.
Step 9 For SSH sessions, choose the allowed SSH version(s) from the drop-down list.