Filter
Top Products
11-43
Cisco ASDM User Guide
OL-16647-01
Chapter 11 Configuring Dynamic And Static Routing
Static Routes
• Interface—(Display only) Lists the internal or external network interface name enabled in
Interfaces.
• IP Address—(Display only) Lists the internal or external network IP address. Use 0.0.0.0 to specify
a default route. The 0.0.0.0 IP address can be abbreviated as 0.
• Netmask—(Display only) Lists the network mask address that applies to the IP address. Use 0.0.0.0
to specify a default route. The 0.0.0.0 netmask can be abbreviated as 0.
• Gateway IP—(Display only) Lists the IP address of the gateway router, which is the next hop address
for this route.
• Metric—(Display only) Lists the administrative distance of the route. The default is 1 if a metric is
not specified.
• Options—(Display only) Displays any options specified for the static route.
–
None—No options are specified for the static route.
–
Tunneled—Specifies route as the default tunnel gateway for VPN traffic. Used only for default
route. You can only configure one tunneled route per device. The tunneled option is not
supported under transparent mode.
–
Tracked—Specifies that the route is tracked. The tracking object ID and the address of the
tracking target are also displayed. The tracked option is only supported in single, routed mode.
Modes
The following table shows the modes in which this feature is available:
Add/Edit Static Route
Use the Add/Edit Static Route dialog box to configure the static route properties. This dialog box is
available from both the Static Routes screen in the Startup Wizard and the Configuration > Routing >
Static Route pane.
Fields
• Interface Name—Select the egress interface for the route.
• IP Address—Specifies the internal or external network IP address. Use 0.0.0.0 to specify a default
route. The 0.0.0.0 IP address can be abbreviated as 0.
• Mask—Specifies the network mask address that applies to the IP address. Use 0.0.0.0 to specify a
default route. The 0.0.0.0 netmask can be abbreviated as 0.
• Gateway IP—Specifies the IP address of the gateway router, which is the next hop address for this
router.
• Metric—Lets you specify the administrative distance of the route. The default is 1 if a metric is not
specified.
The following options are available for static routes. You can select only one of these options for a static
route. By default, no option (None) is selected.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—