Filter
Top Products
24-33
Cisco ASDM User Guide
OL-16647-01
Chapter 24 Configuring Application Layer Protocol Inspection
Service Policy Field Descriptions
Modes
The following table shows the modes in which this feature is available:
Select GTP Map
The Select GTP Map dialog box lets you select or create a new GTP map. A GTP map lets you change
the configuration values used for GTP application inspection. The Select GTP Map table provides a list
of previously configured maps that you can select for application inspection.
Note GTP inspection requires a special license. If you try to enable GTP application inspection on a
security appliance without the required license, the security appliance displays an error message.
Fields
• Use the default GTP inspection map—Specifies to use the default GTP map.
• Select an GTP map for fine control over inspection—Lets you select a defined application
inspection map or add a new one.
• Add—Opens the Add Policy Map dialog box for the inspection.
Modes
The following table shows the modes in which this feature is available:
Select H.323 Map
The Select H.323 Map dialog box lets you select or create a new H.323 map. An H.323 map lets you
change the configuration values used for H.323 application inspection. The Select H.323 Map table
provides a list of previously configured maps that you can select for application inspection.
Fields
• Use the default H.323 inspection map—Specifies to use the default H.323 map.
• Select an H.323 map for fine control over inspection—Lets you select a defined application
inspection map or add a new one.
• Add—Opens the Add Policy Map dialog box for the inspection.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—