Filter
Top Products
17-6
Cisco ASDM User Guide
OL-16647-01
Chapter 17 Configuring Logging
Syslog Setup
Step 1 Check the Disable Message(s) check box to disable messages for the syslog message ID(s) displayed in
the Syslog ID(s) list.
Step 2 From the Logging Level drop-down list, choose the severity level of messages to be sent for the syslog
message ID(s) displayed in the Syslog ID(s) list. Severity levels are defined as follows:
• Emergency (level 0, system unusable)
• Alert (level 1, immediate action needed)
• Critical (level 2, critical condition)
• Error (level 3, error condition)
• Warning (level 4, warning condition)
• Notification (level 5, normal but significant condition)
• Informational (level 6, informational message only)
• Debugging (level 7, appears during debugging only)
Step 3 Click OK to close this dialog box.
Modes
The following table shows the modes in which this feature is available:
Advanced Syslog Configuration
You can configure the security appliance to include a device ID in non-EMBLEM-formatted syslog
messages. You can specify only one type of device ID for syslog messages. The device ID can be the
hostname of the adaptive security appliance, an interface IP address, the context, or a text string.
The Advanced Syslog Configuration dialog box lets you determine whether syslog messages should
include a device ID. If this feature is enabled, the device ID is automatically included in all
non-EMBLEM formatted syslog messages.
To specify additional syslog message settings, perform the following steps:
Step 1 Check the Enable syslog device ID check box to specify that a device ID should be included in all
non-EMBLEM formatted syslog messages.
Step 2 To specify which to use as the device ID, choose one of the following options:
• Hostname
• IP address
Choose the interface name that corresponds to the specified IP address from the drop-down list.
• String
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—