Filter
Top Products
1-5
Cisco ASDM User Guide
OL-16647-01
Chapter 1 Welcome to ASDM
Unsupported Commands
Effects of Unsupported Commands
• If ASDM loads an existing running configuration and finds IPv6-related commands, ASDM
displays a dialog box informing you that it does not support IPv6. You cannot configure any IPv6
commands in ASDM, but all other configuration is available.
• If ASDM loads an existing running configuration and finds other unsupported commands, ASDM
operation is unaffected. To view the unsupported commands, choose Tools > Show Commands
Ignored by ASDM on Device.
• If ASDM loads an existing running configuration and finds the alias command, it enters
Monitor-only mode.
Monitor-only mode allows access to the following functions:
–
The Monitoring area
–
The CLI tool (Tools > Command Line Interface), which lets you use the CLI commands
Ta b l e 1-4 List of Unsupported Commands
Unsupported Commands ASDM Behavior
access-list Ignored if not used
capture Ignored
dns-guard Ignored
eject Unsupported
established Ignored.
failover timeout Ignored
icmp-unreachable rate-limit Ignored
ipv6, any IPv6 addresses Ignored
pager Ignored
pim accept-register route-map Ignored. You can configure only the list option
using ASDM.
prefix-list Ignored if not used in an OSPF area
route-map Ignored
service-policy global Ignored if it uses a match access-list class. For
example:
access-list myacl line 1 extended permit ip
any any
class-map mycm
match access-list mycl
policy-map mypm
class mycm
inspect ftp
service-policy mypm global
switchport trunk native vlan Ignored
sysopt nodnsalias Ignored
sysopt uauth allow-http-cache Ignored
terminal Ignored