Filter
Top Products
12-8
Cisco ASDM User Guide
OL-16647-01
Chapter 12 Configuring Multicast Routing
Multicast Route
• Edit—Opens the Add/Edit Multicast Route dialog box. Use this button to change the selected static
multicast route.
• Delete—Use this button to remove the selected static route.
Modes
The following table shows the modes in which this feature is available:
Add/Edit Multicast Route
Use the Add Multicast Route dialog box to add a new static multicast route to the security appliance.
Use the Edit Multicast Route dialog box to change an existing static multicast route.
Fields
• Source Address—Enter the IP address of the multicast source. You cannot change this value when
editing an exiting static multicast route.
• Source Mask—Enter the network mask for the IP address of the multicast source or chose a common
mask from the list. You cannot change this value when editing an exiting static multicast route.
• Source Interface—Choose the incoming interface for the multicast route.
• Destination Interface—(Optional) Choose the outgoing interface for the multicast route. If you
specify the destination interface, the route is forwarded through the selected interface. If you do not
choose a destination interface, then RPF is used to forward the route. You can specify the interface,
or the RPF neighbor, but not both at the same time.
• Admin Distance—Enter the administrative distance of the static multicast route. If the static
multicast route has the same administrative distance as the unicast route, then the static multicast
route takes precedence.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——