Filter
Top Products
11-26
Cisco ASDM User Guide
OL-16647-01
Chapter 11 Configuring Dynamic And Static Routing
Dynamic Routing
–
In—Filters networks on incoming RIP updates.
–
Out—Filters networks from outgoing RIP updates.
• Interface—You can select a specific interface for the filter rule, or you can select the All Interfaces
option to apply the filter to all interfaces.
• Action—(Display only) Displays Permit if the specified network is not filtered from incoming or
outgoing RIP advertisements. Displays Deny if the specified network is to be filtered from incoming
or outgoing RIP advertisements.
• IP Address—(Display only) Displays the IP address of the network being filtered.
• Netmask—(Display only) Displays the network mask applied to the IP address.
• Insert—Click this button to add a network rule above the selected rule in the list. Clicking this button
opens the Network Rule dialog box.
• Edit—Click this button to edit the selected rule. Clicking this button opens the Network Rule dialog
box.
• Add—Click this button to add a network rule below the selected rule in the list. Clicking this button
opens the Network Rule dialog box.
Modes
The following table shows the modes in which this feature is available:
Network Rule
The Network Rule pane allows you to configure permit and deny rules for specific networks in a filter
rule.
Fields
• Action—Select Permit to allow the specified network to be advertised in RIP updates or accepted
into the RIP routing process. Select Deny to prevent the specified network from being advertised in
RIP updates or accepted into the RIP routing process.
• IP Address—Type IP address of the network being permitted or denied.
• Netmask—Specify the network mask applied to the network IP address. You can type a network
mask into this field or select one of the common masks from the list.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——