Filter
Top Products
17-7
Cisco ASDM User Guide
OL-16647-01
Chapter 17 Configuring Logging
E-Mail Setup
In the User-Defined ID field, specify an alphanumeric, user-defined string.
Step 3 Click OK to close this dialog box.
Modes
The following table shows the modes in which this feature is available:
E-Mail Setup
The E-Mail Setup pane lets you set up a source e-mail address as well as a list of recipients for specified
syslog messages to be sent as e-mail messages for notification purposes. You can filter the syslog
messages sent to a destination e-mail address by severity level. The table shows which entries have been
created. To access this pane, choose Configuration > Device Management > Logging > E-Mail Setup.
To configure e-mail to send notification of selected syslog messages, perform the following steps:
Step 1 In the Source E-Mail Address field, specify the e-mail address that is used as the source address for
syslog messages that are sent as e-mail messages.
Step 2 Click Add to enter a new e-mail address recipient of the specified syslog messages.
Step 3 Choose the severity level of the syslog messages that are sent to the recipient from the drop-down list.
The syslog message severity filter used for the destination e-mail address causes messages of the
specified severity level and higher to be sent. The global filter specified in the Logging Filters pane is
also applied to each e-mail recipient. For more information, see Logging Filters, page 17-10.
Step 4 Click Edit to modify an existing the severity level of the syslog messages that are sent to this recipient.
Step 5 Click OK to close this dialog box.
Modes
The following table shows the modes in which this feature is available:
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—