Filter
Top Products
11-30
Cisco ASDM User Guide
OL-16647-01
Chapter 11 Configuring Dynamic And Static Routing
Dynamic Routing
Step 10 (Optional) Control the sending and receiving of default route information in EIGRP updates on the
Default Information pane. By default, default routes are sent and accepted. See Default Information,
page 11-39 for more information.
Field Information for the EIGRP Panes
This section contains the following topics:
• Setup, page 11-30
• Filter Rules, page 11-34
• Interface, page 11-35
• Redistribution, page 11-36
• Static Neighbor, page 11-37
• Summary Address, page 11-38
• Default Information, page 11-39
Setup
Enable and EIGRP process and configure the basic setting for that process on the Setup pane. The Setup
pane contains the following tabs:
• Process Instances, page 11-30
• Networks, page 11-32
• Passive Interfaces, page 11-33
Modes
The following table shows the modes in which this feature is available:
Process Instances
The Process Instances tab lets you enable an EIGRP routing process.
Fields
• Enable this EIGRP Process—Check this check box to enable an EIGRP routing process. You can
only enable one EIGRP routing process on the device. You must enter an autonomous system
number for the routing process in the EIGRP Process field before you can save your change.
• EIGRP Process—Enter the autonomous system number for the EIGRP process. The autonomous
system number can be from 1 to 65535.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• — • ——