Filter
Top Products
122
CHAPTER 4 BUS INTERFACE
<Note>
Before writing to the MODR, set the bus width, equal to that set by the MD2, MD1, and MD0
pins, in BW1 and BW0 of AMD0.
The bus width of area 0 is specified by the MD2, MD1, and MD0 pins at reset time. After setting
the mode register (MODR), the bus width set in AMD0 becomes valid.
Suppose that the width of area 0 is set to 16 bits by the MD2, MD1, and MD0 pins, and wiring to
the MODR is performed without setting AM0 with the bus width left as is. As the initial value of
BW1 and BW0 of AMD0 is "00", the bus width changes to 8 bits, thereby causing an error.
MODR write
RSTX (reset)
CS0 bus width MD2, MD1, and MD0 pins AMD0 register