3Com WX2200 3CRWX220095A Switch User Manual


 
Port and VLAN Configuration Scenario 101
===============================================================================
Boot Time: 2000-03-18 22:59:19
Uptime: 0 days 00:13:45
===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok temp2 ok temp3 ok
PSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missing
Memory: 156.08/496.04 (31%)
Total Power Over Ethernet : 0.000
===============================================================================
3 Configure ports 2 through 4 for connection to MAP model AP2750 and
verify the configuration changes. Type the following commands:
WX1200# set port type ap 2-4 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
WX1200# display port status
Port Name Admin Oper Config Actual Type Media
===============================================================================
1 mgmt up up auto 100/full network 10/100BaseTx
2 finance up up auto 100/full ap 10/100BaseTx
3 accounting up up auto 100/full ap 10/100BaseTx
4 shipping up up auto 100/full ap 10/100BaseTx
5 lobby up up auto 100/full network 10/100BaseTx
6 lobby up up auto 100/full network 10/100BaseTx
7 conf_room1 up up auto 100/full network 10/100BaseTx
8 conf_room1 up up auto 100/full network 10/100BaseTx
WX1200# display port poe
Link Port PoE PoE
Port Name Status Type config Draw(Watts)
===============================================================================
1 mgmt up - disabled off
2 finance up MAP enabled 7.11
3 accounting up MAP enabled 7.11
4 shipping up MAP enabled 7.11
5 lobby up - disabled off
6 lobby up - disabled off