3Com WX2200 3CRWX220095A Switch User Manual


 
256 CHAPTER 10: CONFIGURING MAP ACCESS POINTS
Displaying MAP
Information
You can display the following MAP information:
MAP and radio-specific configuration settings
Connection information for Distributed MAPs configured on a WX
List of Distributed MAPs that are not configured on a WX
Connection information for Distributed MAPs
Service profile information
Radio profile information
Status information
Information about static IP addresses on Distributed MAPs
Statistics counters
Information about VLAN profiles configured for local switching
ARP table on an MSP
Forwarding Database (FDB) for an MSP
Information about the VLANs locally switched by a MAP
Information about ACLs used by the MAP
Displaying MAP
Configuration
Information
To display configuration information, use the following commands:
display ap config [apnumber [radio {1 | 2}]]
The command lists information separately for each MAP.
To display configuration information for MAP 59, type the following
command:
WX1200# display ap config 59
AP 59: serial-id: 1231, AP model: MP-422, bias: high, name:
AP59
upgrade-firmware: YES
force-image-download: NO
communication timeout: 10
location:
contact:
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 18, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,