3Com WX2200 3CRWX220095A Switch User Manual

Displaying Multicast Information 373
Adding or Removing
a Static Multicast
Router Port
To add or remove a static multicast router port, use the following
set igmp mrouter port port-list {enable | disable}
Adding or Removing
a Static Multicast
Receiver Port
To add a static multicast receiver port, use the following command:
set igmp receiver port port-list {enable | disable}
You can use the CLI to display the following IGMP snooping information:
Multicast configuration information and statistics
Multicast queriers
Multicast routers
Multicast receivers
Displaying Multicast
Information and
To display multicast configuration information and statistics, use the
following command:
display igmp [vlan vlan-id]
The display igmp command displays the IGMP snooping state, the
settings of all multicast parameters you can configure, and multicast
To display multicast information for VLAN orange, type the following
WX1200# display igmp vlan orange
VLAN: orange
IGMP is enabled
Proxy reporting is on
Mrouter solicitation is on
Querier functionality is off
Configuration values: qi: 125 oqi: 300 qri: 100 lmqi: 10 rvalue: 2 Multicast
router information:
Port Mrouter-IPaddr Mrouter-MAC Type TTL
---- --------------- ----------------- ----- -----
1 00:01:02:03:04:05 dvmrp 17
Group Port Receiver-IP Receiver-MAC TTL
--------------- ---- --------------- ----------------- ----- none none none undef 5 00:02:04:06:08:0b 258