3Com WX2200 3CRWX220095A Switch User Manual


 
148 CHAPTER 7: CONFIGURING SNMP
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectInterferingRogueAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectInterferingRogueDisappearTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectRogueAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectRogueDisappearTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedMacAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedSsidAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedOuiTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedSsidTraps
success: change accepted.
Configuring a
Notification Target
A notification target is a remote device to which MSS sends SNMP
notifications. You can configure the MSS SNMP engine to send confirmed
notifications (informs) or unconfirmed notifications (traps). Some of the
command options differ depending on the SNMP version and the type of
notification you specify. You can configure up to 10 notification targets.
To configure a notification target for informs from SNMPv3, use the
following command:
set snmp notify target target-num ip-addr[:udp-port-number]
usm inform user username
snmp-engine-id {ip | hex hex-string}
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
[retries num]
[timeout num]