Filter
Top Products
206 CHAPTER 10: CONFIGURING MAP ACCESS POINTS
(To configure a service profile, see “Configuring a Service Profile” on
page 233.)
web-portal-acl portalacl
Note: This is the
default only if
the fallthru type
on the service
profile has been
set to
web-portal.
Otherwise, the
value is
unconfigured.
If set to portalacl and the service profile
fallthru is set to web-portal, radios use
the portalacl ACL to filter traffic for
Web Portal users during authentication.
If the fallthru type is web-portal but
web-portal-acl is set to an ACL other
than portalacl, the other ACL is used.
If the fallthru type is not web-portal,
radios do not use the web-portal-acl
setting.
web-portal-form Not configured For WebAAA users, serves the default
login web page or, if configured, the
SSID-specific login web page.
web-portal-session-
timeout
5 Allows a Web Portal WebAAA session
to remain in the Deassociated state 5
seconds before being terminated
automatically.
wep key-index No keys defined Uses dynamic WEP rather than static
WEP.
Note: If you configure a WEP key for
static WEP, MSS continues to also
support dynamic WEP.
wep
active-multicast-index
1 Uses WEP key 1 for static WEP
encryption of multicast traffic if WEP
encryption is enabled and keys are
defined.
wep
active-unicast-index
1 Uses WEP key 1 for static WEP
encryption of unicast traffic if WEP
encryption is enabled and keys are
defined.
wpa-ie disable Does not use the WPA IE in transmitted
frames.
Table 10 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter
Set to Default Value