Filter
Top Products
Configuring MAPs 249
To configure antenna model ANT1060 for an MP-262 on MAP 1, type
the following command:
WX1200# set ap 1 radio 1 antennatype ANT1060
success: change accepted.
Specifying the External Antenna Location
In some cases, the set of valid channels for a radio differs depending on
whether the antenna is located indoors or outdoors. You can ensure that
the proper set of channels is available on the radio by specifying the
antenna’s location (indoors or outdoors). The default location is
indoors.
To change an external antenna’s location, use the following command:
set {ap port-list | dap dap-num} antenna-location {indoors |
outdoors}
Mapping the Radio
Profile to Service
Profiles
To assign SSIDs to radios, you must map the service profiles for the SSIDs
to the radio profile that is assigned to the radios.
To map a radio profile to a service profile, use the following command:
set radio-profile name service-profile name
The following command maps service-profile wpa_clients to radio profile
rp2:
WX1200# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
Assigning a Radio
Profile and Enabling
Radios
To assign a radio profile to radios, use the following command:
set ap apnumber radio {1 | 2} radio-profile name
mode {enable | disable}
To assign radio profile rp1 to radio 1 on ports 1-3 and 6 and enable the
radios, type the following command:
WX1200# set ap 1-3,6 radio 1 radio-profile rp1 mode enable
success: change accepted.
To assign radio profile rp1 to radio 2 on ports 1-4 and port 6 and enable
the radios, type the following command:
WX1200# set ap 1-4,6 radio 2 radio-profile rp1 mode enable
success: change accepted.