3Com WX2200 3CRWX220095A Switch User Manual


 
Locating an RFID Tag 325
WX1200# set ap 69 radio 1 channel 7
success: change accepted.
WX1200# set ap 67 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WX1200# set ap 68 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WX1200# set ap 69 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
Locating an RFID Tag You can use an AeroScout Engine or 3Com Wireless Switch Manager to
locate an asset to which an RFID tag is attached.
Using an AeroScout
Engine
1 Load the site map in AeroScout System Manager.
2 Mark the origin point (0,0), if not already done.
3 Calibrate distance, if not already done.
4 Add each MAP configured as a listener to the map, and enter its IP
address.
To look up a Distributed MAP IP address, use the display ap status
command.
5 Enable RSSI location calculation.
6 Enable tag positioning.
7 Enable the map to use the MAPs.
To check the status of a MAP, right-click on the MAP icon and select
Status.
Using 3Com Wireless
Switch Manager
If your network is modeled in a 3Com Wireless Switch Manager network
plan, you can use 3Com Wireless Switch Manager to locate devices that
have AeroScout asset tags. This capability requires the following:
Three or more listeners are required for optimal location results. 3Com
Wireless Switch Manager will attempt to display a tag’s location even if
there are fewer than three listeners, but the location might not be accurate.
The listener MAPs must be in the network plan, on the floor where
the asset tags are located.