3Com WX2200 3CRWX220095A Switch User Manual


 
356 CHAPTER 17: CONFIGURING AND MANAGING SPANNING TREE PROTOCOL
Resetting the STP Port Priority to the Default Value
To reset the STP port priority to the default value, use one of the
following commands:
clear spantree portpri port-list
clear spantree portvlanpri port-list {all | vlan vlan-id}
The command applies only to the ports you specify. The port cost on
other ports remains unchanged.
Changing the STP Port Priority
To change the priority of a port, use one of the following commands:
set spantree portpri port-list priority value
set spantree portvlanpri port-list priority value {all |
vlan vlan-id}
The set spantree portpri command changes the priority for ports in the
default VLAN (VLAN 1) only. The set spantree portvlanpri command
changes the priority for ports in a specific other VLAN or in all VLANs.
Specify a priority from 0 (highest priority) through 255 (lowest priority).
The default is 128.
The all option applies the change to all VLANs. Alternatively, specify an
individual VLAN.
To set the priority of ports 3 and 4 in the default VLAN to 48, type the
following command:
WX1200# set spantree portpri 3-4 priority 48
success: change accepted.
To set the priority of ports 3 and 4 to 48 in VLAN mauve, type the
following command:
WX1200# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
Resetting the STP Port Priority to the Default Value
To reset the STP port priority to the default value, use one of the
following commands:
clear spantree portpri port-list
clear spantree portvlanpri port-list {all | vlan vlan-id}