3Com WX2200 3CRWX220095A Switch User Manual


 
222 CHAPTER 10: CONFIGURING MAP ACCESS POINTS
MAP Parameters:
set dap auto bias {high | low}
set dap auto blink {enable | disable}
set dap auto force-image-download {enable | disable}
set dap auto group name
set dap auto mode {enable | disable}
set dap auto persistent [apnumber | all]
set dap auto upgrade-firmware {enable | disable}
Radio Parameters:
set dap auto radiotype {11a | 11b | 11g}
set dap auto radio {1 | 2} auto-tune max-power power-level
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-profile name mode {enable |
disable}
Enabling the Auto-AP Profile To enable the Auto-AP profile for
automatic Distributed MAP configuration, type the following command:
WX# set ap auto mode enable
success: change accepted.
Specifying the Radio Profile Used by the Auto-AP Profile The
Auto-AP profile uses radio profile default by default. To use another radio
profile instead, use the following command:
set ap auto radio {1 | 2}
radio-profile name mode {enable | disable}
The following command changes the Auto-AP profile to use radio profile
autodap1 for radio 1:
WX# set ap auto radio 1 radio-profile autodap1
success: change accepted.
You must configure the radio profile before you can apply it to the
Auto-AP profile.