3Com WX2200 3CRWX220095A Switch User Manual


 
294 CHAPTER 13: CONFIGURING USER ENCRYPTION
Displaying WPA Settings
To display the WPA settings in a service profile, use the following
command:
display service-profile {name | ?}
To display the WPA settings in effect in service profile wpa, type the
following command:
WX1200# display service-profile sp1
ssid-name: private ssid-type: crypto
Beacon: yes Proxy ARP: no
DHCP restrict: no No broadcast: no
Short retry limit: 5 Long retry limit: 5
Auth fallthru: none Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page: Custom agent-directory:
Static COS: no COS: 0
CAC mode: none CAC sessions: 14
User idle timeout: 180 Idle client probing: yes
Keep initial vlan: no Web Portal Session Timeout: 5
Web Portal ACL:
WEP Key 1 value: <none> WEP Key 2 value: <none>
WEP Key 3 value: <none> WEP Key 4 value: <none>
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 30000ms
11a beacon rate: 6.0 multicast rate: AUTO
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate: 2.0 multicast rate: AUTO
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate: 2.0 multicast rate: AUTO
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0,
36.0,48.0,54.0
The WPA settings appear at the bottom of the output.
The WPA fields appear in the display service-profile output only when
WPA is enabled.