3Com WX2200 3CRWX220095A Switch User Manual


 
112 CHAPTER 6: CONFIGURING AND MANAGING IP INTERFACES AND SERVICES
To add two default routes and configure MSS to always use the route
through 10.2.4.69 when the WX interface to that default router is up,
type the following commands:
WX1200# set ip route default 10.2.4.69 1
success: change accepted.
WX1200# set ip route default 10.2.4.17 2
success: change accepted.
To add an explicit route from a WX switch to any host on the 192.168.4.x
subnet through the local router 10.5.4.2, and give the route a cost of 1,
type the following command:
WX1200# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1
success: change accepted.
Removing a Static
Route
To remove a static route, use the following command:
clear ip route {default | ip-addr mask | ip-addr/mask-length}
default-router
After you remove a route, traffic that uses the route can no longer reach
its destination. For example, if you are managing the WX switch with a
Telnet session and the session needs the static route, removing the route
also removes the Telnet connection to the switch.
The following command removes the route to 192.168.4.69/24 that uses
default router 10.2.4.1:
WX1200# clear ip route 192.168.4.69/24 10.2.4.1
success: change accepted.
The following command removes the default route that uses default
router 10.5.5.5:
WX1200# clear ip route default 10.5.5.5
success: change accepted.