3Com WX2200 3CRWX220095A Switch User Manual


 
Configuring WPA 293
The passphrase must be from 8 to 63 characters long, including blanks. If
you use blanks, you must enclose the string in quotation marks.
To configure service profile wpa to use passphrase
1234567890123<>?=+&% The quick brown fox jumps over the lazy sl,
type the following command:
WX1200# set service-profile wpa psk-phrase "1234567890123<>
?=+&% The quick brown fox jumps over the lazy sl"
success: change accepted.
As an alternative to entering a passphrase, which MSS converts into a
key, you can enter the key itself in raw hexadecimal format. To enter a
PSK key in raw format, use the following command:
set service-profile name psk-raw hex
For hex, type a 64-bit ASCII string representing a 32-digit hexadecimal
number. Enter the two-character ASCII form of each hexadecimal
number.
To configure service profile wpa to use a raw PSK with PSK clients, type a
command such as the following:
WX1200# set service-profile wpa psk-raw c25d3fe4483e867d1df96
eaacdf8b02451fa0836162e758100f5f6b87965e59d
success: change accepted.
Disabling 802.1X Authentication for WPA
To disable 802.1X authentication for WPA clients, use the following
command:
set service-profile name auth-dot1x {enable | disable}
This command does not disable 802.1X authentication for non-WPA
clients.
To disable WPA authentication in service profile wpa, type the following
command:
WX1200# set service-profile wpa auth-dot1x disable
success: change accepted.