3Com WX2200 3CRWX220095A Switch User Manual


 
246 CHAPTER 10: CONFIGURING MAP ACCESS POINTS
You must disable all radios that are using a radio profile before you can
remove the profile. (See “Disabling or Reenabling All Radios Using a
Profile” on page 250.)
To disable the radios that are using radio profile rptest and remove the
profile, type the following commands:
WX1200# set radio-profile rptest mode disable
WX1200# clear radio-profile rptest
success: change accepted.
Configuring
Radio-Specific
Parameters
This section shows how to configure the channel and transmit power on
individual radios, and how to configure for external antennas. (For
information about the parameters you can set on individual radios, see
Table 13.)
Configuring the Channel and Transmit Power
To set the channel and transmit power of a radio, use the following
commands:
set ap apnumber radio {1 | 2} channel channel-number
set ap apnumber radio {1 | 2} tx-power power-level
If RF Auto-Tuning is enabled for channels or power, you cannot set the
channels or power manually using the commands in this section. See
Chapter 14, “Configuring RF Auto-Tuning,” on page 311.
To set the channel and transmit power of a radio, use the following
commands:
set ap apnumber radio {1 | 2} channel channel-number
set ap apnumber radio {1 | 2} tx-power power-level
The parameters are shown in separate commands for simplicity.
However, you can use the channel and tx-power parameters on the
same command line.
Specify 1 or 2 for the radio number:
For a single-radio model, specify radio 1.
For the 802.11b/g radio in a two-radio model, specify radio 1.
For the 802.11a radio in a two-radio model, specify radio 2.