3Com WX2200 3CRWX220095A Switch User Manual


 
IP Interfaces and Services Configuration Scenario 135
IP Interfaces and
Services
Configuration
Scenario
This scenario configures IP interfaces, assigns one of the interfaces to be
the system IP address, and configures a default route, DNS parameters,
and time and date parameters.
1 Configure IP interfaces on the mgmt and roaming VLANs, and verify the
configuration changes. Type the following commands:
WX1200# set interface mgmt ip 10.10.10.10/24
success: change accepted.
WX1200# set interface roaming ip 10.20.10.10/24
success: change accepted.
WX1200# display interface
VLAN Name Address Mask Enabled State
---- --------------- --------------- --------------- ------- -----
2 default 10.10.10.10 255.255.255.0 YES Up
3 roaming 10.20.10.10 255.255.255.0 YES Up
4094 web-aaa 10.10.10.1 255.255.255.0 YES Up
The 10.10.10.1 interface in VLAN web-aaa is placed into the route table
automatically by MSS, to support WebAAA.
2 Configure the IP interface on the roaming VLAN to be the system IP
address and verify the configuration change. Type the following
commands:
WX1200# set system ip-address 10.20.10.10
success: change accepted.
WX1200# display system
===============================================================================
Product Name: WX1200
System Name: WX1200
System Countrycode: US
System Location:
System Contact:
System IP: 10.02.10.10
System idle timeout:3600
System MAC: 00:0B:0E:00:04:0C
===============================================================================
Boot Time: 2000-03-18 22:59:19
Uptime: 0 days 01:12:02
===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok temp2 ok temp3 ok
PSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missing
Memory: 156.08/496.04 (31%)
Total Power Over Ethernet : 105.6
===============================================================================