Filter
Top Products
Configuring Rogue Detection Lists 575
If you add a device that MSS has classified as a rogue to the permitted
vendor list, but not to the ignore list, MSS can still classify the device as a
rogue. Adding an entry to the permitted vendor list merely indicates that
the device is from an allowed vendor. However, to cause MSS to stop
classifying the device as a rogue, you must add the device’s MAC address
to the ignore list.
To add an entry to the permitted vendor list, use the following command:
set rfdetect vendor-list {client | ap} mac-addr
The following command adds an entry for clients whose MAC addresses
start with aa:bb:cc:
WX1200# set rfdetect vendor-list client aa:bb:cc:00:00:00
success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.
The trailing 00:00:00 value is required.
To display the permitted vendor list, use the following command:
display rfdetect vendor-list
The following example shows the permitted vendor list on a switch:
WX1200# display rfdetect vendor-list
Total number of entries: 1
OUI Type
----------------- ------
aa:bb:cc:00:00:00 client
11:22:33:00:00:00 ap
To remove an entry from the permitted vendor list, use the following
command:
clear rfdetect vendor-list {client | ap} {mac-addr | all}
The following command removes client OUI aa:bb:cc:00:00:00 from the
permitted vendor list:
WX1200# clear rfdetect vendor-list client aa:bb:cc:00:00:00
success: aa:bb:cc:00:00:00 is no longer in client
vendor-list.