Filter
Top Products
528 CHAPTER 22: CONFIGURING COMMUNICATION WITH RADIUS
The members of the group remain configured, although no server groups
are shown:
WX1200# display aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server Addr Ports T/o Tries Dead State
-------------------------------------------------------------------
sandpiper 192.168.253.3 1812 1813 5 3 0 UP
heron 192.168.253.1 1812 1813 5 3 0 UP
coot 192.168.253.4 1812 1813 5 3 0 UP
egret 192.168.253.2 1812 1813 5 3 0 UP
Server groups
RADIUS and Server
Group
Configuration
Scenario
The following example illustrates how to declare four RADIUS servers to a
WX switch and configure them into two load-balancing server groups,
swampbirds and shorebirds:
1 Configure RADIUS servers. Type the following commands:
WX1200# set radius server pelican address 192.168.253.11 key elm
WX1200# set radius server seagull address 192.168.243.12 key fir
WX1200# set radius server egret address 192.168.243.15 key pine
WX1200# set radius server sandpiper address 192.168.253.17 key oak
2 Place two of the RADIUS servers into a server group called swampbirds.
Type the following command:
WX1200# set server group swampbirds members pelican seagull
3 Enable load balancing for swampbirds. Type the following command:
WX1200# set server group swampbirds load-balance enable
4 Place the other RADIUS servers in a server group called shorebirds. Type
the following command:
WX1200# set server group shorebirds members egret pelican
sandpiper
5 Enable load balancing for shorebirds. Type the following command:
WX1200# set server group shorebirds load-balance enable